1.The machine works on the technology of the electric synchronous control. The welding process and the welding time are set by the system programmable logic controller. 2.Input panel constitute a touch screen and keyboard that makes programming the machine a more logical and intelligent that also has the features : hard to compress again ; repeated welding . 3.The machine operates by a motor, has a feed chute that runs from the stepper motor , the longitudinal wire is supplied with brake motor , and pull the mesh by the introduction of the stepper motor. 4. Lengthwise and cross fed wire are pre-straightened and cut, and therefore, tolkko it turns out the grid map .The advantage of this machine : there are different cells between the longitudinal wires. Technical parameters Item Model LM-3A LM-3A/250 LM-3A/210 LM-3A/120 Mesh width 900-2500mm 900-2100мм 900-1200mm Mac. number of electrodes 48 42 24 Longitudinal wire diameter 3-6mm Cross wire diameter 3-6mm Rasstoyanie between the longitudinal rods 50-300mm Rasstoyanie between poperechnyj rods of 25-300mm Mac. length of mesh 6000 mm Line and cross wire cut wire with hopper Mac. welding speed 50 rows/min The type of grid maps Material low carbon , galvanized wire Power 380 V Dimensions 8*3,2*1,75 m 8*2,8*1,75 m 8*1,8*1,75 m Application : mainly used for Expressway , Railways ,airport , housing ,shopping cart , shelf display, etc .