1. This equipment is our last developed welding equipped for the manufacture of reinforcing mesh, powered by electric motor . 2. Lengthwise and cross fed wire are pre-straightened and cut. The longitudinal wire is supplied with the servo moves get the grid automatically. 3. The force on the welding mechanism is transmitted from the electric motor , so that the pressure on the welding electrodes easily controlled. The transverse wire is fed from the universal hopper, which is ten times more than conventional feed device ,can be up to 1T at the same time . 4. This equipment also has a wire tray tool, which makes work more convenient. Welding unit the machine has an elastic bunkers that allow you to use a welding electrode over a long time. The machine works on the technology of the electric synchronous control. 5. The welding process and the welding time are set by the system programmable logic controller. The input panel is a touch screen that makes programming the machine a more logical and intelligent. 6. This year we began to use transformers with water cooling. These transformers are equipped with cooling unit and heat transfer system, allowing time to take away excess warmth. Despite the fact that the diameter of the machine was increased, it did not affect his performance. Technical parameters Item Model LM-12 Wire diameter 5,0-12,0 mm Feed the longitudinal wire is Discontinuous wire Cross-wire Discrete wire Cell 100*100-300*300 Nutrition 400-1000v The number of electrodes 24 Mesh width 1100-2500mm Mac. speed 50 rows/min Dimensions 26*5*2,3 m Mac. length of 12000mm Weight 14T